PROGRESS REPORT WEEK 1 FYP 2

Title: Designing the Circuit and Simulation.

Objectives:

1. To design the circuit that will provide protection to the undervoltage and overcurrent condition
2. To find the suitable component and equipment in order to provide the stability and functionality to the circuit.
3. To understand the datasheet of every component to prevent error and to ensure its compatible to the intended function of the circuit.
4. To run the the simulation using proteus software.
5. To verify the functionality of the circuit.

Method:

1. The circuit design based on the knowledge on electrical and electronic principle.
2.The datasheet of the component is referred in order to know the functionality and specification of the component.
2. After the circuit is designed, the simulation is run using ISIS Proteus software.
3. The circuit is modify and analyzed until its meets the functionality and stability.


Designing and Simulation using ISIS Proteus Software

Conclusion

The circuit has been designed and simulate. However, further research about design, component datasheet and arrangement need to be review and modify in order the circuit to operate in full functionality and reach the objectives.



Comments

Post a Comment

Popular posts from this blog

PROGRESS REPORT WEEK 12

Title: Study about Component and Device Objectives To identify the component that have potential to use in the project To study about the working principle of the component and the device To identify the most suitable component and device that will be used in the project Content Find the component that suit with the working principle of the project Make comparison between model of component and device that has same function Try to understand the working principle of the device and component that will use Choose the suitable component. Result I get better understanding about the working principle of the component that i will used. I also decided whether to try construct the component and device or get the ready made before implement it into the project. In this week, i have choose the important component that i will used in my project. Conclusion  I get better image and understanding about the hardrware and component that i will used in my project Ti...
Read more

PROGRESS REPORT WEEK 13 FYP 2

Image
1. Title: Testing the Circuit at Laboratory Objectives: 1. To make sure the circuit is fully function and follow the objectives 2. To use the equipment and power source from the power laboratory to test the circuit 3. To gather the result after the circuit is tested Method: 1. In order to test the circuit, I enter the power laboratory PEL114 to used the equipment there 2. The equipment needed in lab in order to test the circuit is used. As example: Voltmeter, AC source, Ammeter and load. 3.The circuit is calibrated in order to operate according to the real situation. 4. The result that generated after test the circuit is gathered. Testing the Circuit While in the Lab Conclusion The circuit is successfully tested and the result is gathered. Thank you to the Mr Badrul for the cooperation in assisting me while testing the circuit. 2. Title: Final Final Year Project 2 Briefing On the 3rd November 2017 i have attended the third FYP 2 Briefing that have bee...
Read more

INTRODUCTION TO FINAL YEAR PROJECT 1 ( BACHELOR OF ENGINEERING TECHNOLOGY IN ELECTRICAL) 2017 UNIKL BMI

Image
In semester 6, students in BET Electrical need to fulfill the Final Year Projects 1 course that are consist of 4 credit hour. The marks for this subject all consist of long term assesment without having final year exam. In this semester, me ( Muhammad Fikryl Hakim Bin Zakaria ) have choose one project titles in order to complete this course. The title that have been choose is Development of Over voltage and Over Current Protection Devices . To go all through 17 weeks in this course, i will be guided by my Supervisor, Mr Nor Azman Bin Othman. Muhammad Fikryl Hakim Bin Zakaria 51211114165 930829-03-6015 Phone No: 0199614520
Read more